The ability of a wall, floor, or ceiling to resist the transmission of airborne sound is expressed by its Sound Transmission Class (STC) rating. For example if the sound on one side of a wall is measured at 100 decibels and drops to 60 decibels on the other side, the wall blocks 40 decibels of sound and earns an STC rating of 40. STC ratings are given to a variety of wall assemblies based on acoustical testing.
The STC rating is a lab test that does not take into consideration weak points, penetrations, or flanking paths.
NRC and STC are exclusive of one another. A material with high NRC will help to absorb sound, yet the same material may have a low STC and allow a large amount of sound to pass through into an adjacent room.

How to improve the STC of a wall structure?

Adding Mass

The weight or thickness of a partition is the major factor in its ability to block sound. For example, a thick concrete wall will block more sound than a thin gypsum 2×4 wall. Mass is commonly added to existing walls by adding additional layers of gypsum. When the mass of a barrier is doubled, the isolation quality (or STC rating) increases by approximately 5 dB, which is clearly noticeable.
NOTE: IMT uses 2 layers of 5/8” MDF which has lower sound transfer characteristics than gypsum

Increasing or Adding Air Space

An air space within a partition can also help to increase sound isolation. This, in effect creates two independent walls. However, the STC will be much less than the sum of the STC for the individual walls. The airspace can be increased or added to an existing partition. A common way to add an airspace is with resilient channels and a layer of gypsum. An airspace of 1 1/2” will improve the STC by approximately 3 dB. An air space of 3” will improve the STC by approximately 6 dB. An airspace of 6” will improve the STC by approximately 8 dB.
Note: IMT has an air space of 2 3/4” making it one of the larger air spaces in the modular wall market

Adding Absorptive Material in the Partition

Sound absorptive material can be installed inside of a partition’s air space to further increase its STC rating. Installing insulation within a wall or floor/ceiling cavity will improve the STC rating by about 4-6 dB, which is clearly noticeable. It is important to note that often times, specialty insulations do not perform any better than standard batt insulation.

Note: IMT can incorporate upto 3″ of batt insulation in all solid wall cavities

Even with a high STC rating, any penetration, air-gap, or “flanking” path can seriously degrade the isolation quality of a wall. Flanking paths are the means for sound to transfer from one space to another other than through the wall. Sound can flank over, under or around a wall. Sound can also travel through common problem areas like ductwork, plumbing pipes or chases and corridors. To improve acoustical separations, we recommend reducing all potential transmission points when insulating the walls.

We’re Leaders of

Modular Wall Solutions.

Get a Quote Today